Flarestack Nanopaint provides good corrosion protection to non-immersed metal surfaces from ambient temperature up to 1110°F (600°C) and in thermal cycling conditions. Suggested use primarily as a corrosion protection for Flare Stacks and other high temperature atmospheric serviceapplications. It is also used as an under-insulation corrosion barrier to prevent problems associated with CUI.

Flarestack Nanopaint should be applied at substrate temperatures below 122°F (50°C) and temperaturesabove 46°F (8°C). Flarestack Nanopaint must not be applied to surfaces at elevated temperatures. Do notapply to damp or wet surfaces.

When using this product, safety precautions should be observed. Avoid contact with the eyes and skin. Suitable protective clothing should be worn. Ensure good
ventilation and wear a vapor mask recommended for hydrocarbon solvent vapors. Read the Health and Safety Sheets before using the product.

Wherever possible abrasive grit blast cleaning to SSPC–SP10 (ISO Standard 8501-1 Sa 2½) or equivalent shouldbe used (for full details, refer to Corrocoat data sheetSP1). UHP water blasting may be used to NACE No 5 / SSPC – SP12WJ-2/L standard, the substrate must be dry before application of the material. Flarestack Nanopaint can be applied over a mechanically prepared substrate but this will lead to a deterioration in performance. Remove any surface grease, oil or other contamination using a suitable solvent or degreasing agent. Remove any loose material from the surface by mechanical means and complete using suitable equipment to a standard not lower than ST2

Approximately 43.6%

400-480 sf per gal (10-12 m² / L)

530 sf per gal (13 m²/L).

0.03 lbs/cubic inch (1.03 g/cm³

82°F (28°C).

80°F (27°C) (Closed Cup method).