Product reference:
Product title:
Valid from:
Last reviewed:
Type
Suggested use
A top coat suitable for overcoating ZF and other epoxy based primers where decorative appearance
and chemical resistance are of importance and mainly for use in atmospheric conditions.
Health & safety
Before handling or using this product, the material safety
data sheet should be read and all precautions observed.
Limitations
Not suitable for immersion conditions above 122°F (50°C).
Not resistant to polar solvents.
Thinners
Thinning this product is not recommended.
Packaging
1 Gallon and 5 Gallon kits.
Storage life
2 years minimum in unopened tins, stored at 41-104°F (5-40°C)
Specific gravity
Base and activator mixed 0.04lbs/cubic inch (1.1 gms/cc)
Activator type
Polyamine
Cleaning solvent
Acetone, Methyl Ethyl Ketone, Xylene and epoxy
equipment cleaner.
Flash point
77°F (25°C)
Mixing ratio / mixing
2.5:1 Base to activator by weight. Pour all of component ‘A’ into component ‘B’ and mix thoroughly. The material is now ready for use and should be applied as soon as possible.
Application equipment
Brushes.
Pot Life
50 minutes at 68°F (20°C).
Color availability
White, Yellow, Green, Blue, Red, Grey, Black
Theoretical spreading rate
244 sf per gal (6m² per litre)
Practical spreading rate
224 sf per gal (5.5m² per litre)Note: This information is given in good faith but may increase dependent upon environment conditions, the geometryand nature of work undertaken and the skill and care of application. Corrocoat accepts no responsibility for any deviation from these values.
Mixing ratio
2.5: 1 base to activator by weight.
Chemical resistance
Good.
Cure time
Tack free:Approximately 8 hours at 68°F (20°C) Full cure:2-3 days at 68°F (20°C) Will vary significantly with temperature.