As a laminating resin, used in conjunction with multi
directional roving or other reinforcing materials.
Corrocoat Epoxy Laminating Resin may be over-coated
with any of the Plasmet or Corrocoat Epoxy products; it has
excellent structural properties.

Should not be applied at temperatures below 41°F (5°C),
where dew point is within 5° of air temperature or where
humidity conditions exceed 87%.

Read and observe the Health & Safety data sheet prior
to use.

Corrocoat Epoxy Laminating Resin (ELR) may be applied
directly on to correctly prepared steel substrates, grit blasted
to SSPC-SP10 (ISO 8501-1 SA 2½) or equivalent
standard. Full instructions are in the Corrocoat Data
Sheets SP1 and SP2. ELR may also be applied over other
Corrocoat epoxy products.
For best results on concrete it is recommended the
substrate is primed using Plasmet ECPbefore application of
reinforcement.

100 Parts base: 57 parts activator.
Adhesion promoter: maximum 2% of total mix.

Brush, roller, dipping or spray in certain conditions.

Whether or not the surface is already primed or coated,
wet the substrate using the laminating (ELR) resin. Soak
the reinforcement/roving in the ELR to ensure that it is
thoroughly wetted out. Apply the soaked roving on to the
surface while the roving and primer are still wet. Ensure
there are no ridges or air bubbles present (these may be
removed using a hard grooved or spiked roller while the
resin is still wet). Apply ELR directly on to any ‘dry’ or lightly
wetted areas in the reinforcement and ensure full wet out
with airrelease